1.            Measure: Measure glass and cut the film 12mm larger than actual surface.

2.            Spray: Spray glass and the Solarstat “EazyTint” film thoroughly with a glass cleaner before applying Solarstat “EazyTint”.
NEVER INSTALL ON A DRY SURFACE.  FOR EASIER HANDLING SPRAY THE SURFACE OF THE FILM APPLYING.
This will prevent the film from clinging to itself.

3.            Apply: Starting at the top, apply Solarstat “EazyTint”to the window. There is no front or back to the film so either side can be applied to the glass. Position and smooth out most wrinkles and large bubbles until the film overlaps the frame. If the film begins to cling to itself apply additional window cleaner.

4.            Squeegee: Spray the surface of the film with window cleaner and squeegee out the excess air and moisture from between the film and the glass.

5.            Trim: Allow approx. 20-30 minutes of drying time before trimming. Use a straight edge ruler to press Solarstat “EazyTint” to the inside edge of the window frame. Leave approximately 1mm of glass exposed around the perimeter of the window to allow the film to properly adhere to the surface of the glass.

6.            Touch Up: Spray the surface of the film again and squeegee the edges firmly against the glass. Any excess moisture should evaporate within a few days. During the first 10 hours after installation Solarstat “EazyTint” should not be disturbed.

VEHICLE WINDOW TINTING INSTALLATION

ENSURE YOU CHECK WITH YOUR LOCAL AUTHORITIES FOR RESTRICTIONS REGARDING THE USE OF WINDOW TINT ON AUTOMOBILES. THERE ARE PENALTIES FOR FAILING TO COMPLY WITH WINDOW TINTING REGULATIONS.

NOTE: Do not allow the film to contact the “black dot matrix” of any window as the film must only contact the glass.

Follow Steps 1-5 in the Application Instructions. When aligning and trimming, Solarstat “EazyTint” for vehicle application, it is recommended to first work on the outside of the vehicle’s windows. This allows for easier access to windows during trimming. For roll-up windows, leave an extra 10-15mm along the bottom edge. This will be necessary later to prevent the film from being peeled back during window operation.

After final trimming to size, remove the film from the outside and apply to the inside of the vehicle, repeating Steps 3 and 4. Using a credit card or butter knife, slide the 10-15mm excess below the bottom rubber gasket before aligning the film to the sides and top of the window.

DO NOT ROLL THE WINDOW UP OR DOWN FOR 48-60 HOURS FOLLOWING APPLICATION TO ALLOW THE MOISTURE TO EVAPORATE BELOW THE RUBBER GASKET.

GENERAL INFORMATION

·              If bubbles occur at any time during installation, simply peel back the affected area and re apply. Solarstat “EazyTint” can be removed, repositioned or re applied at any given time.

·              If you intend to Solarstat “EazyTint” seasonally, it is recommended that you label and save the paper and packaging for storage. Simply release the static bond by getting a fingernail under a corner of the film and peel from window. Re roll the film in the appropriately marked paper and place it in the packaging for storage.

·              Solarstat “EazyTint” can be applied to most windows with ordinary household window cleaner. If applying the film to plastic, it is recommended that you check with the manufacturer before using any ammonia-based window cleaner.

·              After installation, Solarstat “EazyTint” may appear slightly cloudy or tiny pinhead bubbles may appear. This condition will improve as the moisture dries between the film and the glass over the next 10-14 days.