Crystal
Privacy Before
applying the film to glass, the clear cellophane backing must be removed
from the material.
Follow the directions below to remove the cellophane backing
Go
to the corner of the film and attach a piece of tape to the finished
(embossed) side. Allow
about one inch of the tape to extend over the edge of the film.
Repeat
step 1 on the same corner of the back (cellophane) side of the film.
Allow
the tape to stick to itself by approximately one inch past the edge of
the film. Press the tape
together tightly.
Slowly
pull the two pieces of tape apart from each other. The clear
cellophane should adhere to
the piece of tape for removal.
Follow
the applications instructions indicate above to complete your
installation.
General
Information
If
at any time bubbles do occur, simply peel back the area affected and
re-apply. Bubbles that
are visible only from the glass side are due to insufficient moisture
during application; spray a
generous amount of soapy water solution to fully saturate the glass
and material before squeegee.
It
is recommend that you save the paper and/or packing for removal and
storage.
Clean
and maintain your window film with any household window cleaner and a
lint free cloth.
.jpg)