Etched Film Corners from Solarstat static window films

back

Installing Static Cling Window Films

Decorative

Spray the glass liberally with a soapy water solution before applying your window decoration. A
sufficient amount of moisture is required between the decoration and glass to give an even
appearance once dried.

Peel the window decoration from the paper backing and position it on the surface of the glass. Use
your hands to smooth out any large bubbles. It is necessary to place the side of the decoration
that is on the backing paper to the glass. If the patterns are to face each other, apply one to the
interior and one to the exterior of the surface.

NEVER INSTALL ON A DRY SURFACE. For easier handling, spray the surface of the window
decoration after removing it from the paper backing and before applying. This will prevent the film
from cling to itself.

Spray the surface of the window decoration with a soapy water solution. Using a soft, rubber tipped
squeegee, squeegee out the excess air and moisture. DO NOT USE A HARD, PLASTIC TIPPED
SQUEEGEE, AS IT MAY SCRATCH THE SURFACE OF THE WINDOW DECORATION.

Wipe dry with a lint free cloth. If bubbles appear between the window decoration and the surface,
repeat Step 4. Any excess moisture should begin to evaporate within 24 hours.